ASTM-F1311 › Historical Revision Information
Standard Specification for Large-Diameter Fabricated Carbon Steel Flanges

ASTM-F1311 - 1990 R06 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:


This specification provides design and construction criteria for large diameter flanges for use in high temperature, low pressure service such as internal combustion engine exhaust and forced ventilation systems. The flanges shall be classified according to types as follows: Type I and Type II. Number of holes, hole diameter, and bolt circle are identical for both Type I and Type II flanges. Drilling of flanges shall be in accordance with the specified requirements.

ORDER

Scope

1.1 This specification provides design and construction criteria for large diameter flanges sizes 14 to 144 NPS, for use in high temperature (1000°F), low pressure service (25 psig), such as internal combustion engine exhaust and forced ventilation systems.

1.2 Values stated in inch-pound units are to be regarded as the standard.

Keywords

carbon steel; flanges; large-diameter flanges; low pressure service flanges; marine technology; ships; ICS Number Code 23.040.60 (Flanges, couplings and joints)

To find similar documents by ASTM Volume:

01.07 (Ships and Marine Technology)

To find similar documents by classification:

23.040.60 (Flanges, couplings and joints)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-F1311-90(2006)

Revision Level

1990 R06 EDITION

Status

Superseded

Modification Type

Reapproval

Publication Date

Dec. 1, 2006

Document Type

Specification

Page Count

3 pages

Committee Number

F25.11