ASTM-F1364 › Historical Revision Information
Standard Practice for Use of a Calibration Device to Demonstrate the Inspection Capability of an Interferometric Laser Imaging Nondestructive Tire Inspection System
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This standard practice describes the construction and use of a calibration device for demonstrating the anomaly detection capability of interferometric laser imaging nondestructive tire inspection system. A common practice within the industry is to refer to these systems as shearographic/holographic (S/H) systems.
1.2 This standard practice applies to S/H systems that are used for evaluating the structural integrity of pneumatic tires, (for example, presence or absence of anomalies within the tire).
1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
calibration; holography;inspection; nondestructive; shearography; tire; ICS Number Code 31.260 (Optoelectronics. Laser equipment)
To find similar documents by ASTM Volume:
09.02 (Rubber Products, Industrial - Specifications and Related Test Methods; Gaskets; Tires)
To find similar documents by classification:
31.260 (Optoelectronics. Laser equipment Including photoelectric tubes and cells)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F1364-92(1997)e1
Revision Level
1992 R97(E1) EDITION
Status
Superseded
Modification Type
Reapproval with Ed Change
Publication Date
March 1, 1998
Document Type
Practice
Page Count
2 pages
Committee Number
F09.10