ASTM-F145 › Historical Revision Information
Standard Practice for Evaluating Flat-Faced Gasketed Joint Assemblies
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice permits measurement of gasket compression resulting from bolt loading on a flat-face joint assembly at ambient conditions.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
compressed thickness; flange distortion; flat-face joint; gasket compression; solder plug test; ICS Number Code 21.140 (Seals, glands)
To find similar documents by ASTM Volume:
09.02 (Rubber Products, Industrial - Specifications and Related Test Methods; Gaskets; Tires)
To find similar documents by classification:
21.140 (Seals, glands Seals for pipe and hose assemblies, see 23.040.80)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F145-72(1997)
Revision Level
1972 R97 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Jan. 1, 1997
Document Type
Practice
Page Count
3 pages
Committee Number
F03.20