ASTM-F1516 › Historical Revision Information
Standard Practice for Sealing Seams of Resilient Flooring Products by the Heat Weld Method (when Recommended)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice covers the instructions and precautions to be observed to ensure satisfactory performance of seams in resilient flooring sealed by the heat weld method.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See precaution information in 6.1.
Significance and Use
Seams in some resilient flooring are heat sealed to prevent openings from forming between cut edges and to prevent penetrations of dirt, liquids, etc., into the seams. Decorative appearances may also be achieved using contrasting heat weld thread (rod).
Keywords
heat weld; installationl; resilient sheet flooring; resilient tile; sealing; ICS Number Code 13.220.40 (Ignitability and burning behaviour of materials and products); 97.150 (Non-textile floor coverings)
To find similar documents by ASTM Volume:
15.04 (Soaps and Other Detergents; Polishes; Leather; Resilient Floor Coverings)
To find similar documents by classification:
13.220.40 (Ignitability and burning behaviour of materials and products)
97.150 (Non-textile floor coverings Textile floor coverings, see 59.080.60)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F1516-03
Revision Level
2003 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Sept. 10, 2003
Document Type
Practice
Page Count
2 pages
Committee Number
F06.40