ASTM-F19 › Historical Revision Information
Standard Test Method for Tension and Vacuum Testing Metallized Ceramic Seals
The following bibliographic material is provided to assist you with your purchasing decision:
This test method establishes the standard procedures for conducting tension and vacuum tests on metal-ceramic seals to determine the bond strength of brazed, metalized ceramics. This test method is, however, not to be considered as an absolute tension test for the ceramic. This method requires the use of appropriate testing machines and various types of gripping devices.
Scope
1.1 This test method covers procedures for conducting tension and vacuum tests on metal-ceramic seals to determine the bond strength of brazed, metallized ceramics. This test method is not to be considered as an absolute tension test for the ceramic.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
brazing; leak rate test; metallized ceramic seals; tension testing; ICS Number Code 21.140 (Seals, glands)
To find similar documents by ASTM Volume:
10.04 (Electronics; Declarable Substances in Materials; 3D Imaging Systems)
To find similar documents by classification:
21.140 (Seals, glands Seals for pipe and hose assemblies, see 23.040.80)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F19-64(2005)e1
Revision Level
1964 R05(E1) EDITION
Status
Superseded
Modification Type
Reapproval with Ed Change
Publication Date
Jan. 1, 2005
Document Type
Test Method
Page Count
4 pages
Committee Number
F01.03