ASTM-F1971 › Historical Revision Information
Standard Test Method for Electrical Resistance of Tires Under Load On the Test Bench
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method describes the measurement of the electrical resistance between the wheel of a mounted and inflated tire-wheel assembly and a flat conducting surface in loaded contact with the tire.
1.2 The method specifies procedures and equipment such that electrical resistance can be accurately determined for tires with values up to 1012 ohms.
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
electrical resistance; load; test bench; tires; ICS Number Code 83.160.01 (Tyres in general)
To find similar documents by ASTM Volume:
09.02 (Rubber Products, Industrial - Specifications and Related Test Methods; Gaskets; Tires)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F1971-99
Revision Level
1999 EDITION
Status
Superseded
Modification Type
New
Publication Date
April 10, 1999
Document Type
Test Method
Page Count
3 pages
Committee Number
F09.30