ASTM-F37 › Historical Revision Information
Standard Test Methods for Sealability of Gasket Materials
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods provide a means of evaluating the sealing properties of sheet and solid form-in-place gasket materials at room temperature. Test Method A is restricted to liquid leakage measurements, whereas Test Method B may be used for both liquid and gas leakage measurements.
1.2 These test methods are suitable for evaluating the sealing characteristics of a gasket material under different compressive flange loads. The test method may be used as an acceptance test when the producer and user have agreed to specific test conditions for the following parameters: test medium, internal pressure on medium, and flange load on gasket specimens.
1.3 These test methods use a small-diameter narrow-width gasket as the test specimen under relatively low gasket loads and relatively low pressures. Test Method F2378 is another sealability test method that uses a larger gasket specimen and higher internal pressures and flange loads.
1.4 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. (For specific hazard or warning statements, or both, see 5.2.11, Section 6, 6.3, 8.2.4, 11.3.2, and 11.4.2.)
Significance and Use
4.1 These test methods are designed to compare gasket materials under controlled conditions and to provide a precise measure of leakage rate.
4.2 These test methods are suitable for measuring leakage rates as high as 6 L/h and as low as 0.3 mL/h. In many cases, “zero” leakage may not be attainable.
4.3 These test methods evaluate leakage rates after time periods that are typically 5 to 30 min under load. Holding a gasket material under load for extended time periods may give different results.
4.4 If the fluid being used in the test causes changes, such as swelling, in the gasket material, then unpredictable results may be obtained.
Keywords
flange; fluid; gas; gasket materials; leakage; manometer; pressure; sealability
To find similar documents by ASTM Volume:
09.02 (Rubber Products, Industrial - Specifications and Related Test Methods; Gaskets; Tires)
To find similar documents by classification:
21.140 (Seals, glands Seals for pipe and hose assemblies, see 23.040.80)
23.100.60 (Filters, seals and contamination of fluids Hydraulic fluids, see 75.120)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F37-06(2013)
Revision Level
2006 R13 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
June 1, 2013
Document Type
Test Method
Page Count
8 pages
Committee Number
F03.10