Document Center is acquired by Nimonik

Scope

1.1 These test methods provide a means of evaluating the sealing properties of sheet and solid form-in-place gasket materials at room temperature. Test Method A is restricted to liquid leakage measurements, whereas Test Method B may be used for both liquid and gas leakage measurements.

1.2 These test methods are suitable for evaluating the sealing characteristics of a gasket material under different compressive flange loads. The test method may be used as an acceptance test when the supplier and the purchaser have agreed to specific test conditions for the following parameters: test medium, internal pressure on medium, and flange load on gasket specimens.

1.3 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. (For specific hazard statements, see Section 6, Note 3, and Note 8.)

Keywords

Gaskets; Leak testing-gasket materials; Sealability; sealability of gasket materials, test; ICS Number Code 23.100.60 (Filters, seals and contamination of fluids); 73.080 (Non-metalliferous minerals)

To find similar documents by ASTM Volume:

09.02 (Rubber Products, Industrial - Specifications and Related Test Methods; Gaskets; Tires)

To find similar documents by classification:

21.140 (Seals, glands Seals for pipe and hose assemblies, see 23.040.80)

23.100.60 (Filters, seals and contamination of fluids Hydraulic fluids, see 75.120)

73.080 (Non-metalliferous minerals Including mica, fluorspar, etc. Industrial diamonds, see 25.100 Precious and semi-precious stones, see 39.060)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.