ASTM-F410 › Historical Revision Information
Standard Test Method for Wear Layer Thickness of Resilient Floor Coverings by Optical Measurement
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of the thickness of the wear layer of resilient non-textile floor coverings, in tile or sheet form, with or without felt backing or foam layer, by optical measurement.
1.2 This test method is applicable for wear layers with a minimum thickness of 0.0004 in. (0.01 mm) to a maximum thickness of 0.1 in. (2.54 mm), where measurements within 0.0001 in. or 0.0025 mm are tolerable.
1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
measurement; optical; resilient; test; thickness; wear layer; ICS Number Code 97.150 (Non-textile floor coverings)
To find similar documents by ASTM Volume:
15.04 (Soaps and Other Detergents; Polishes; Leather; Resilient Floor Coverings)
To find similar documents by classification:
97.150 (Non-textile floor coverings Textile floor coverings, see 59.080.60)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F410-87
Revision Level
1987 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Aug. 28, 1987
Document Type
Test Method
Page Count
2 pages
Committee Number
F06.20