ASTM-F73 › Standard Specification for Tungsten-Rhenium Alloy Wire for Electron Devices and Lamps
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers tungsten-rhenium alloy wire suitable for use in electron devices and lamps. The material is known as UNS R07031. This wire shall conform to the requirements as to chemical composition prescribed. The wire shall be furnished in the following finishes: Finish 1; Finish 2; Finish 3; Finish 4; and Finish 5. The following test methods shall be performed to conform with the specified requirements: chemical analysis; tensile strength; ductility; visual inspection; and dimensional measurements.
Scope
1.1 This specification covers tungsten-rhenium alloy wire suitable for use in electron devices and lamps. The material is known as UNS R07031.
1.2 The term wire as used in this specification applies to all material 0.020 in. (0.51 mm) or less in diameter that is spooled or coiled.
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Keywords
electron devices; tungsten-rhenium alloy; UNS R07031 ;
To find similar documents by ASTM Volume:
10.04 (Electronics; Declarable Substances in Materials; 3D Imaging Systems)
To find similar documents by classification:
29.060.10 (Wires Including electric rods, busbars, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
MIL-STD-810Environmental Engineering Considerations and Laboratory Tests
ASTM-A484
Standard Specification for General Requirements for Stainless Steel Bars, Billets, and Forgings
MIL-STD-2073/1
Standard Practice for Military Packaging
Document Number
ASTM-F73-96(2017)
Revision Level
1996 R17 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
June 1, 2017
Document Type
Specification
Page Count
3 pages
Committee Number
B10.04