ASTM-F85 › Historical Revision Information
Standard Practice for Nomenclature for Wire Leads Used as Conductors in Electron Tubes
The following bibliographic material is provided to assist you with your purchasing decision:
This practice covers the rules for naming one, two, or three-piece round wire leads used as conductors through glass seals in electron tubes, excluding stranded leads and leads for semiconductors. Each portion of designation should be separated by a dash (-). Materials for a component lead are generally designated using the chemical symbols. Claddings or platings are represented by numerical suffixes at the end of the material designation preceded by "C" (coating). For alloys that are unspecified, a numerical value between chemical symbols indicates the percent content of the material preceding the value. Descriptive suffixes are used to specify annealing conditions.
Scope
1.1 This practice covers rules for designating one, two, or three-piece round wire leads used as conductors through glass seals in electron tubes. Stranded leads and leads for semiconductors are excluded.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
annealing conditions; electron tubes; wire leads—glass seals; ICS Number Code 01.040.31 (Electronics (Vocabularies)); 31.100 (Electronic tubes)
To find similar documents by ASTM Volume:
10.04 (Electronics; Declarable Substances in Materials; 3D Imaging Systems)
To find similar documents by classification:
01.040.31 (Electronics (Vocabularies))
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F85-76(2013)
Revision Level
1976 R13 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
May 15, 2013
Document Type
Practice
Page Count
3 pages
Committee Number
F01.03