ASTM-F959 › Historical Revision Information
Standard Specification for Compressible-Washer-Type Direct Tension Indicators for Use with Structural Fasteners
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers the requirements for four types (Types 325, 325-3, 490, and 490-3) of compressible-washer-type direct tension indicators, in nominal diameter sizes ½ through 1 ½ in., capable of indicating the achievement of a specified minimum bolt tension in a structural bolt and are intended for installation under either a bolt head or a hardened washer. Steel materials used in the manufacture of direct tension indicators shall be designed, processed, heat treated, and protectively coated as specified. The direct tension indicators shall conform to required chemical composition, compression load, and dimensional values.
Scope
1.1 This specification covers the requirements for compressible-washer-type direct tension indicators capable of indicating the achievement of a specified minimum bolt tension in a structural bolt.
1.2 Four types of direct tension indicators in nominal diameter sizes ½ through 1 ½ in. are covered:
1.2.1 Type 325—direct tension indicators for use with Specification A 325
1.2.2 Type 325–3—direct tension indicators for use with Specification A 325
1.2.3 Type 490—direct tension indicators for use with Specification A 490
1.2.4 Type 490–3—direct tension indicators for use with Specification A 490
1.3 Direct tension indicators are intended for installation under either a bolt head or a hardened washer. (See Research Council on Structural Connections: Specification for Structural Joints Using ASTM A 325 or A 490 Bolts.)
1.4 The following precautionary statement pertains only to the test method portions, Section 12 and Appendix X1 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
compressible-washer-type; direct tension indicators; DTI; indicators; Compressible washer-type indicators; Direct tension indicators (DTI); Fasteners (metal) specifications; Indicators; Structural building materials/applications specifications; Structural fasteners; Tensile properties/testing metallic materials; ICS Number Code 21.060.01 (Fasteners in general)
To find similar documents by ASTM Volume:
01.08 (Fasteners; Rolling Element Bearings)
To find similar documents by classification:
21.060.01 (Fasteners in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F959-07a
Revision Level
2007A EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Dec. 1, 2007
Document Type
Specification
Page Count
5 pages
Committee Number
F16.02