BS-122-6 › Historical Revision Information
Milling cutters. Specification for dimensions for interchangeability of cutter arbors and cutter mandrels
BS-122-6
-
REPLACED BY BS-ISO-240
-
SUPERSEDED
-- See the following:
BS-ISO-240
Show Complete Document History
Show Complete Document History
Document Center Inc. is an authorized dealer of BSI standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
Milling cutters
Keywords
Dimensions;Spindles;Key-driven cutters;Conversion (units of measurement);Cutting tools;Interchangeability;Preferred sizes;Milling cutters;Dimensional tolerances;Mandrels;Tenon-driven cutters
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
BS-122-6
Revision Level
REPLACED BY BS-ISO-240
Status
Superseded
Publication Date
Aug. 31, 2016
International Equivalent
ISO 240:1994
Committee Number
W/-