IEC-62137-1-4 › Surface mounting technology - Environmental and endurance test methods for surface mount solder joint - Part 1-4: Cyclic bending test
IEC-62137-1-4
-
EDITION 1.0
-
CURRENT
Document Center Inc. is an authorized dealer of IEC standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
The test method described in IEC 62137-1-4:2009 applies to surface mount components with a thin and wide basal plane, such as QFP and BGA. This test method evaluates the endurance of the solder joints between component leads and lands on a substrate by cyclic bending of substrate. This test also evaluates the effects of repeated mechanical stress, such as key pushing in cell phones, the strength of the solder joint between component terminals and lands on a substrate.
To find similar documents by classification:
31.190 (Electronic component assemblies Including preassembled modules)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
IEC 62137-1-4 Ed. 1.0 b:2009
Revision Level
EDITION 1.0
Status
Current
Publication Date
Jan. 1, 2009
Committee Number
91