ISO-10242-1 › Historical Revision Information
Tools for pressing - Punch holder shanks - Part 1: Type A
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 10242-1:2011 specifies the interchangeability dimensions and tolerances, in millimetres, of punch holder shanks with neck and flats, type A, intended for use in press tools.
ISO 10242-1:2011 gives guidance on the materials, and specifies the hardness and designation of punch holder shanks in accordance with the specified requirements.
To find similar documents by classification:
25.120.10 (Forging equipment. Presses. Shears)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 10242-1:1991
Revision Level
1ST EDITION
Status
Superseded
Publication Date
Dec. 1, 1991
Committee Number
ISO/TC 29/SC 8