ISO-10350-2 › Plastics - Acquisition and presentation of comparable single-point data - Part 2: Long-fibre-reinforced plastics
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 10350 identifies specific test procedures for the acquisition and presentation of comparable data for certain basic properties of plastics. In general, each property is specified by a single experimental value, although in certain cases properties are represented by two values obtained under different test conditions or along different directions in the material. The properties included are those presented conventionally in manufacturers' data sheets.
This document applies to reinforced thermoplastic and thermosetting materials where the reinforcement fibres are either discontinuous with a fibre length prior to processing greater than 7,5 mm or continuous (e.g. fabric, continuous-strand mat or unidirectional).
ISO 10350-1 deals specifically with unreinforced and filled plastics, including those using fibres less than 7,5 mm in length.
To find similar documents by classification:
83.120 (Reinforced plastics Materials for the reinforcement of plastics, see 59.100)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 10350-2:2020
Revision Level
3RD EDITION
Status
Current
Publication Date
July 1, 2020
Committee Number
ISO/TC 61/SC 2