ISO-11119-3 › Historical Revision Information
Amendment 1: Gas cylinders - Design, construction and testing of refillable composite gas cylinders and tubes - Part 3: Fully wrapped fibre reinforced composite gas cylinders and tubes up to 450 l with non-load-sharing metallic or non-metallic liners or without liners - Amendment 1
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 11119-3:2013 specifies requirements for composite gas cylinders up to 150 l water capacity and composite tubes above 150 l water capacity and up to 450 l water capacity, for the storage and conveyance of compressed or liquefied gases.
The cylinders and tubes in ISO 11119-3:2013 are
- Type 4 Fully Wrapped Cylinders or Tubes with a non-load sharing liner and composite reinforcement on both the cylindrical portion and the dome ends, and
- Type 5 Fully Wrapped Cylinders or Tubes without liners (including cylinders without liners manufactured from two parts joined together) and with a test pressure of less than 60 bar.
The cylinders are constructed
- in the form of a disposable mandrel overwrapped with carbon fibre or aramid fibre or glass fibre (or a mixture thereof) in a resin matrix to provide longitudinal and circumferential reinforcement, and
- in the form of two filament wound shells joined together.
Cylinders and tubes manufactured and tested to ISO 11119-3:2013 are not intended to contain toxic, oxidizing or corrosive gases.
ISO 11119-3:2013 is limited to cylinders and tubes with composite reinforcement of carbon fibre or aramid fibre or glass fibre (or a mixture thereof) in a matrix.
Cylinders and tubes manufactured and tested to ISO 11119-3:2013 have a minimum design life of 15 years.
ISO 11119-3:2013 does not address the design, fitting and performance of removable protective sleeves.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO-11119-3
Revision Level
FOR 3RD EDITION AMENDMENT 1 SEE
Status
Current
Publication Date
July 1, 2023
Committee Number
ISO/TC 58/SC 3