ISO-11414 › Historical Revision Information
Plastics Pipes & Fittings - Preparation of Polyethylene (Pe) Pipe/Pipe or Pipe/Fitting

ISO-11414 - 1ST EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:


ISO 11414:2009 specifies a method for preparing butt-fusion-jointed test piece assemblies between polyethylene (PE) pipes and spigot-ended fittings.

ISO 11414:2009 specifies the assembly parameters involved, such as the ambient temperature, joint geometry and fusion parameters, taking into account the service condition limits specified in the relevant product standards, as well as the type of pipe to be used.

ISO 11414:2009 is intended to enable the effect of site assembly variables on joint performance to be determined. The fusion-jointing procedures and parameters used in the field can differ from those in ISO 11414:2009, depending on the manufacturer's written procedures and/or local standards.

ORDER

To find similar documents by classification:

23.040.60 (Flanges, couplings and joints)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ISO 11414:1996

Revision Level

1ST EDITION

Status

Superseded

Publication Date

June 1, 1996

Committee Number

ISO/TC 138/SC 5