ISO-12129-2 › Historical Revision Information
Part 2: Tolerances on Form & Position & Surface Roughness for Shafts, Flanges & Thrust Col
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
Specifies tolerances on form and position as well as the surface roughness of shafts, flanges and thrust collars as used in plain bearing units. Applicable to journal or thrust plain bearing units or to a combination of both, installed either horizontally or vertically. Not applicable to crankshaft bearing units in combustion engines.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 12129-2:1995
Revision Level
1ST EDITION
Status
Superseded
Publication Date
April 1, 1995
Committee Number
ISO TC 123/SC 3