ISO-1268-3 › Fibre-reinforced plastics -- Methods of producing test plates -- Part 3: Wet compression moulding
The following bibliographic material is provided to assist you with your purchasing decision:
This part of ISO 1268 specifies a method of making test plates by wet compression moulding. Using this method, test plates can be made in a reproducible manner, making it possible to compare the results of tests carried out at different times and/or in different places.
Test specimens cut from plates made by wet compression moulding are useful in characterizing the reinforcement used. The reinforcement can be either mats or fabrics. The following properties of these materials are of particular interest:
- water absorption (ISO 62);
- flexural strength and flexural modulus (ISO 178);
- impact strength (Charpy) (ISO 179);
- tensile strength, tensile modulus and elongation at break (ISO 527-4).
This part of ISO 1268 is intended to be used in conjunction with ISO 1268-1.
To find similar documents by classification:
83.120 (Reinforced plastics Materials for the reinforcement of plastics, see 59.100)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 1268-3:2000
Revision Level
1ST EDITION
Status
Current
Publication Date
Nov. 1, 2000
Committee Number
ISO TC 61/SC 13/WG 16