ISO-128-34 › Historical Revision Information
Part 34: Views on Mechanical Engineering Drawings, Technicaldrawings - General Principles
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This part of ISO 128 specifies rules for the presentation of views additional to those of ISO 128-30 and applicable to mechanical engineering drawings that follow the orthographic projection methods specified in ISO 5456-2. Attention has also been given to reproduction requirements, including those of microcopying according to ISO 6428.
To find similar documents by classification:
01.100.20 (Mechanical engineering drawings)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 128-34:2001
Revision Level
1ST EDITION
Status
Superseded
Publication Date
Jan. 15, 2001
Committee Number
ISO TC 10/SC 6