ISO-13012-1 › Historical Revision Information
Rolling bearings - Accessories for sleeve type linear ball bearings - Part 1: Boundary dimensions and tolerances for series 1 and 3
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 13012-1:2009 specifies the boundary dimensions, other relevant dimensions and their tolerances of accessories for sleeve type linear ball bearings which are specified in ISO 10285.
ISO 13012-1:2009 applies to: housings — closed and adjustable flangeless housings for series 1 sleeve type linear ball bearings, closed and adjustable flanged housings for series 3 sleeve type linear ball bearings, open flanged housings for series 3 sleeve type linear ball bearings, closed and adjustable flangeless housings for series 3 sleeve type linear ball bearings, open and open adjustable flangeless housings for series 3 sleeve type linear ball bearings; shaft support rails — standard height shaft support rails for series 3 sleeve type linear ball bearings, low height shaft support rails for series 3 sleeve type linear ball bearings; shaft support blocks — flanged shaft support blocks for series 1 and 3 sleeve type linear ball bearings, flangeless shaft support blocks for series 1 and 3 sleeve type linear ball bearings; shafts — solid and tubular shafts for series 1 and 3 sleeve type linear ball bearings.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 13012-1:2009
Revision Level
1ST EDITION
Status
Superseded
Publication Date
Feb. 1, 2009
Committee Number
ISO/TC 4/SC 11