ISO-14743 › Historical Revision Information
Pneumatic Fluid Power - Push-in Connectors for Thermoplastictubes
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 14743:2004 specifies the general requirements and test methods for the design and performance of push-in connectors for use with thermoplastic tubes with outside diameters of 3 mm to 12 mm, inclusive. It is intended to establish uniform methods of testing complete push-in connector assemblies as used in pneumatic fluid power applications. It is not applicable to air braking systems.
To find similar documents by classification:
23.100.40 (Piping and couplings)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 14743:2004
Revision Level
1ST EDITION
Status
Superseded
Publication Date
May 1, 2004
Committee Number
ISO/TC 131/SC 4