ISO-1501 › ISO miniature screw threads
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
Included in this current edition are the following subparts:
1ST EDITION - May 15, 2009
FOR 1ST EDITION AMENDMENT 1 SEE - Jan. 1, 2020
FOR 1ST EDITION AMENDMENT 1 SEE - Jan. 1, 2020
ISO 1501:2009 specifies the profiles, diameter-pitch combinations, basic dimensions, tolerances, limits of size and designation for ISO miniature screw threads with nominal diameters from 0,3 mm to 1,4 mm. These threads are applicable to timepieces, optical instruments, electrical meters, measuring instruments, etc.
The profiles and tolerance system for ISO miniature screw threads (S) differ from the profile and tolerance system for ISO general purpose metric screw threads (M).
To find similar documents by classification:
21.040.30 (Special screw threads Including miniature screw threads, pipe threads, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
AMS-2249Chemical Check Analysis Limits, Titanium and Titanium Alloys
IPC/EIA-J-STD-001
Requirements for Soldered Electrical and Electronic Assemblies
ISO-594-1
Conical fittings with a 6 % (Luer) taper for syringes, needles and certain other medical equipment -- Part 1: General requirements
Document Number
ISO 1501:2009
Revision Level
1ST EDITION
Status
Current
Publication Date
May 15, 2009
Committee Number
ISO/TC 1