ISO-15876-2 › Historical Revision Information
Plastics piping systems for hot and cold water installations - Polybutylene (PB) - Part 2: Pipes
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 15876-2:2003 specifies the characteristics of pipes made from polybutylene (PB) for piping systems intended to be used for hot and cold water installations, within buildings, for the conveyance of water which may or may not be intended for human consumption (domestic systems) or for heating systems, under operating pressures and temperatures appropriate to the class of application.
It covers a range of service conditions (application classes), design pressures and pipe dimension classes. It does not apply if the values of the design temperature, maximum design temperature and malfunction temperature are in excess of those given in ISO 15876-1.
It also specifies the test parameters for the test methods referred to in the standard.
In conjunction with the other parts of ISO 15876, it is applicable to PB pipes and their joints, including joints with other PB components and components made of other plastics and non-plastics materials intended to be used for hot and cold water installations.
It is applicable to pipes with or without (a) barrier layer(s).
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 15876-2:2003
Revision Level
1ST EDITION
Status
Superseded
Publication Date
Dec. 1, 2003
Committee Number
ISO/TC 138/SC 2