ISO-2982-2 › Historical Revision Information
Rolling bearings - Accessories - Part 2: Dimensions for locknuts and locking devices
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 2982-2:2013 specifies:
- dimensions of locknuts;
- runout tolerance of locknut clamp face with respect to pitch diameter of screw thread;
- dimensions of lockwashers with straight inner tab for use with 4-slot locknuts;
- dimensions of locking clip assemblies for use with 8-slot locknuts.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 2982-2:1995
Revision Level
1ST EDITION
Status
Superseded
Publication Date
Sept. 1, 1995
Committee Number
ISO/TC 4