ISO-3940 › Tapered die-sinking cutters with parallel shanks
ISO-3940
-
1ST EDITION
-
CURRENT
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
Lays down the diemnsions of these cutters with plain parallel or parallel flatted shanks. The cutters are particular intended for directly obtained clearances of moulds, patterns and dies, when these exceed 2 52'. Applies to flat-end cutters and ball-nosed cutters. There are short type, medium type, and long type cutters.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 3940:1977
Revision Level
1ST EDITION
Status
Current
Publication Date
June 15, 1977
Committee Number
ISO TC 29