ISO-6117 › Historical Revision Information
Road Vehicles - Elastomeric Boots for Drum-Type, Hydraulic Brake Wheel Cylinders Using
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 6117:2005 specifies performance tests for moulded rubber boots used at end closures on drum type wheel brake cylinders; these boots prevent the entrance of dirt and moisture which could cause corrosion and otherwise impair wheel brake operation.
It is applicable to boots of both plain and reinforcement insert types, for fitting in wheel cylinders using a fluid in accordance with ISO 4925. It does not include requirements relating to chemical composition, tensile strength or elongation at brake of the rubber compound; it dose not cover the strength of adhesion of rubber to the reinforcement in the insert type.
The rubber material used in these boots is suitable for operation in a temperature range of -40 °C to +100 °C.
To find similar documents by classification:
83.140.50 (Seals Seals for general use, see 21.140 and 23.040.80)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 6117:1980
Revision Level
1ST EDITION
Status
Superseded
Publication Date
Aug. 15, 1980
Committee Number
ISO/TC 22/SC 2