ISO-6118 › Historical Revision Information
Road vehicles - Elastomeric cups and seals for hydraulic brake actuating cylinders using a non-petroleum base hydraulic brake fluid (service temperature 70 degrees C max.)
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 6118:2006 specifies performance tests of brake cups and seals for hydraulic braking systems for road vehicles. It does not include requirements relating to chemical composition, tensile strength and elongation of the rubber compound. Disc brake seals are not covered by this International Standard.
ISO 6118:2006 is applicable to moulded seals (cups or double-lipped type gland seals), 60 mm in diameter and smaller, compounded from rubber, for use in hydraulic actuating cylinders employing road vehicle non-petroleum base hydraulic brake fluid conforming to the requirements of ISO 4925.
To find similar documents by classification:
83.140.50 (Seals Seals for general use, see 21.140 and 23.040.80)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 6118:1980
Revision Level
1ST EDITION
Status
Superseded
Publication Date
Oct. 15, 1980
Committee Number
ISO/TC 22/SC 2