ISO-691 › Historical Revision Information
Assembly Tools for Screws & Nuts - Wrench & Socket Openings - Tolerances for General
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 691:2005 specifies tolerances on wrench and socket openings for screws and nuts (or similar parts) having metric width across flats dimensions. It gives, for each dimension, the tolerances for general use, defined by its two deviations, minimum and maximum, with respect to the nominal value. These deviations have been determined in relation to the width across flats tolerances for screws and nuts specified in ISO 4759-1 and with regard to the manufacture of tightening tools.
To find similar documents by classification:
25.140.30 (Hand-operated tools Including wrenches, screwdrivers, pliers, nippers, hammers, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 691:2005
Revision Level
4TH EDITION
Status
Current
Publication Date
Nov. 1, 2005
Committee Number
ISO/TC 29/SC 10