ISO-7919-4 › Historical Revision Information
Mechanical vibration of non-reciprocating machines - Measurements on rotating shafts and evaluation criteria - Part 4: Gas turbine sets

ISO-7919-4 - 1ST EDITION - SUPERSEDED -- See the following: ISO-7919-4-AM1
Show Complete Document History

Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:


ISO 7919-4:2009 establishes provisions for evaluating the severity of in-situ, broad-band shaft vibration measured radial (i.e. transverse) to the shaft axis at, or close to, the main bearings. These are in terms of

- vibration under normal steady-state operating conditions;

- vibration during other (non-steady-state) conditions when transient changes are taking place, including run up or run down, initial loading and load changes;

- changes in vibration which can occur during normal steady-state operation.

ISO 7919-4:2009 is applicable to heavy-duty gas turbine sets used in electrical and mechanical drive applications, with fluid-film bearings, outputs greater than 3 MW and an operating speed range under load between 3 000 r/min and 30 000 r/min. This includes gas turbines coupled to other rotating machinery either directly or through a gearbox. In some cases, ISO 7919-4:2009 is not applicable to the evaluation of the vibration of the coupled equipment.

ORDER

To find similar documents by classification:

17.160 (Vibrations, shock and vibration measurements Including measuring instruments and installations Vibration and shock with respect to human beings, see 13.160 Balancing and balancing machines, see 21.120.40 Vibration protection of buildings, see 91.120.25)

27.040 (Gas and steam turbines. Steam engines Hydraulic turbines, see 27.140)

Document Number

ISO 7919-4:1996

Revision Level

1ST EDITION

Status

Superseded

Publication Date

July 15, 1996

Committee Number

ISO/TC 108/SC 2