ISO-8740 › Historical Revision Information
Grooved pins -- Full length parallel grooved, with chamfer
The following bibliographic material is provided to assist you with your purchasing decision:
This international Standard specifies the characteristics of full-length parallel grooved pins made of steel or austenitic stainless steel with chamfer which have three equally spaced grooves impressed longitudinally on their exterior surface and a pilot to facilitate insertion, with nominal diameter, d1, from 1,5 mm to 25 mm inclusive.
The displaced material to each side of the grooves forming an expanded diameter d2 which is larger than the nominal diameter d1 will cause a non-positive locking fit when these grooved pins are forced into a drilled hole equal to the nominal diameter d1 (see clause 4).
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 8740:1986
Revision Level
1ST EDITION
Status
Superseded
Publication Date
Nov. 1, 1986
Committee Number
ISO TC 2/WG 10