SS-EN-12012-2 › Historical Revision Information
Plastics and rubber machines - Size reduction machines - Part 2: Safety requirements for strand pelletisers
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This standard specifies the essential safety requirements applicable to the design and construction of strand pelletisers used for plastics and rubber and fed continuously by an extruder or a reactor. The machine begins with the feed opening of the feeding device, or start-up devices if fitted, and ends with the discharge area. Only the significant hazards listed in clause 4 and dealt with in clause 5 are subject to this standard. NOTE Directive 94/9/EC concerning equipment and protective systems intended for use in potentially explosive atmospheres can be applicable to the type of machine or equipment covered by this European Standard. The present standard is not intended to provide means of complying with the essential health and safety requirements of Directive 94/9/EC. This standard applies to machines which are manufactured after the date of approval of this standard by CEN.
To find similar documents by classification:
83.200 (Equipment for the rubber and plastics industries)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN 12012-2+A2:2008
Revision Level
2001/A2 EDITION
Status
Superseded
Publication Date
Sept. 22, 2008
Language(s)
English
Page Count
32
International Equivalent
EN 12012-2:2001+A2:2008(IDT)