SS-EN-12201-1 › Historical Revision Information
Plastics piping systems for water supply - Polyethylene (PE) - Part 1: General
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This Part of this European Standard specifies the general aspects of polyethylene (PE) piping systems (mains and service pipes) intended for the conveyance of water for human consumption, including raw water prior to treatment. It also specifies the test parameters for the test methods referred to in this standard. In conjunction with other Parts of this European Standard it is applicable to PE pipes, fittings, valves, their joints and to joints with components of other materials intended to be used under the following conditions: a) a maximum operating pressure, MOP, up to 25 bar 2) ; b) an operating temperature of 20 °C as a reference temperature. NOTE 1 For applications operating at constant temperatures greater than 20 °C and up to 40 °C, see annex A. EN 12201 covers a range of maximum operating pressures and gives requirements concerning colours and additives. NOTE 2 It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects, taking into account their particular requirements and any relevant national guidance or regulations and installation practices or codes.
To find similar documents by classification:
23.040.01 (Pipeline components and pipelines in general)
23.040.05 (Pipelines and its parts for external sewage systems)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN 12201-1
Revision Level
EDITION 1
Status
Superseded
Publication Date
April 4, 2003
Language(s)
English
Page Count
17
International Equivalent
EN 12201-1:2003 IDT