SS-EN-12312-19 Aircraft ground support equipment - Specific requirements - Part 19: Aircraft jacks, axle jacks and hydraulic tail stanchions

SS-EN-12312-19 - 2005/A1 EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:

This document specifies the technical requirements to minimise the hazards listed in Clause 4 which can arise during the commissioning, operation and maintenance of aircraft jacks, axle jacks and hydraulic tail stanchions when carried out in accordance with the specifications given by the manufacturer or his authorised representative. It also takes into account some performance requirements recognised as essential by authorities, aircraft and ground support equipment (GSE) manufacturers as well as airlines and handling agencies. This document applies to: -- all types of aircraft jacks; -- axle jacks and hydraulic tail stanchions designed to be used at specific jacking points on the aircraft (examples see Annex A). NOTE A tail stanchion type is intended to be used with one type of aircraft. This document does not apply to aircraft recovery equipment. This document does not establish requirements for noise and vibration. Noise and vibration are dealt with respectively in EN 1915-4 and EN 1915-3. This Part of EN 12312 is not applicable to aircraft jacks, axle jacks and hydraulic tail stanchions which are manufactured before the date of publication of this document by CEN.

To find similar documents by classification:

49.100 (Ground service and maintenance equipment)

Machinery. In vitro diagnostic medical devices. Revised Machinery Directive

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.




Designation Name

SS-EN 12312-19:2005+A1:2009

Revision Level




Publication Date

May 8, 2009



Page Count


International Equivalent

EN 12312-19:2005+A1:2009(IDT)