SS-EN-12629-6 › Historical Revision Information
Machines for the manufacture of constructional products from concrete and calcium-silicate - Safety - Part 6: Stationary and mobile equipment for the manufacture of precast reinforced products
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
1.1 This document is intended to be used together with EN 12629-1 Machines for the manufacture of constructional products from concrete and calcium-silicate Safety Part 1: Common requirements", which specifies general requirements of machines for the manufacture of constructional products from concrete and calciumsilicate. This document specifies the additional requirements to and/or the deviations from EN 12629-1 specific for the stationary and mobile equipment for the manufacture of precast reinforced products as defined in Clause 3. This document applies to these machines also when used for the manufacture of non-reinforced moulded products. 1.2 This document applies to the modules comprising production machines (with or without turnover demoulding) for the manufacturing of reinforced moulded products as shown below and illustrated in informative Annexes A and B. NOTE This machinery can consist of three modules and they are generally designed to obtain a large moulding capacity (middle length of the products from 3 to 4 meters), with a limit height of demoulding of 1 m and a maximum width of 1,50 m. Module A: Manufacturing machines by vibration or compression and floating, with or without turnover. Module B: Stocking/hardening unit. Module C: Assembly for palletising/packaging of the concrete products. This module also permits the inspection of the products. These machines are designed to perform the following cyclic operations: manufacturing by vibration and even compression (oiling, mould feeding concrete + reinforcement , vibration, floating, interlocking, turnover, removing from mould); storage of moulds and pallet boards for concrete hardening; products destacking and packaging; moulds and pallet boards return to the manufacturing module. Any of these operations may be manual, semi-automatic or automatic.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN 12629-6:2004
Revision Level
2004 EDITION
Status
Superseded
Publication Date
Sept. 3, 2004
Language(s)
English
Page Count
36
International Equivalent
EN 12629-6:2004(IDT)