SS-EN-1395-5 › Historical Revision Information
Thermal spraying - Acceptance inspection of thermal spraying equipment - Part 5: Plasma spraying in chambers
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This European Standard specifies requirements for the acceptance inspection of thermal spraying equipment, in this case the pressurised part only for low pressure and controlled atmosphere plasma spraying, used in spray jobs to produce thermally sprayed coatings of reproducible quality. This part should be used in conjunction with EN 1395-1, which includes general requirements and explanations of procedures. The plasma spraying system itself should be acceptance inspected according to EN 1395-4.
To find similar documents by classification:
25.220.20 (Surface treatment Including anodization, conversion coating, thermal spraying, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN 1395-5:2007
Revision Level
2007 EDITION
Status
Superseded
Publication Date
Feb. 9, 2007
Language(s)
English
Page Count
11