SS-EN-485-1 › Historical Revision Information
Aluminium and aluminium alloys - Sheet, strip and plate - Part 1: Technical conditions for inspection and delivery
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This document specifies the technical conditions for inspection and delivery of wrought aluminium and wrought aluminium alloy sheet, strip and plate for general engineering applications. It also includes provision for ordering and testing. It applies to products with a thickness over 0,20 mm up to and including 400 mm. It does not directly apply to semi-finished rolled products in coiled form to be subjected to further rolling (reroll stock) or to special applications such as aerospace, can stock, finstock, etc. which are dealt with in separate European Standards. NOTE Most of these specific standards refer for some provisions to the present standard.
To find similar documents by classification:
77.120.10 (Aluminium and aluminium alloys)
77.150.10 (Aluminium products)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN 485-1:2008
Revision Level
2008 EDITION
Status
Superseded
Publication Date
March 17, 2008
Language(s)
English
Page Count
28
International Equivalent
EN 485-1:2008(IDT)