SS-EN-754-7 › Historical Revision Information
Aluminium and aluminium alloys - Cold drawn rod/bar and tube - Part 7: Seamless tubes, tolerances on dimensions and form
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
Defines tolerances on dimensions and form for aluminium and aluminium alloy cold drawn seamless tubes with an outside diameter between 3mm and 350 mm, or a cross section contained within a circumscribing circle between 8 mm and 300 mm supplied in straignt lengths. Applicable only to tube made by the seamless die/mandrel extrusion method, (and then cold drawn to the final required dimensions). Not applicable to extruded, cold drawn tube made by the porthole/bridge method, or to coiled tube.
To find similar documents by classification:
77.120.10 (Aluminium and aluminium alloys)
77.150.10 (Aluminium products)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN 754-7
Revision Level
EDITION 1
Status
Superseded
Publication Date
Aug. 7, 1998
Language(s)
English
Page Count
14
International Equivalent
EN 754-7:1998(IDT)