SS-EN-ISO-10893-12 Non-destructive testing of steel tubes - Part 12: Automated full peripheral ultrasonic thickness testing of seamless and welded (except submerged arc-welded) steel tubes (ISO 10893-12:2011)

SS-EN-ISO-10893-12 - 2011 EDITION - CURRENT

Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Included in this current edition are the following subparts:

 2011 EDITION - April 20, 2011
 FOR 2011 EDITION AMENDMENT 1 SEE - June 16, 2020

This part of ISO 10893 specifies requirements for the automated full peripheral ultrasonic testing of seamless and welded steel tubes, with the exception of submerged arc-welded (SAW) tubes, for wall thickness measurement. It specifies the testing method and corresponding calibration procedures. NOTE 1 Full peripheral testing does not necessarily mean that 100 % of the tube surface is scanned. NOTE 2 This test can be carried out simultaneously with full peripheral ultrasonic testing for the detection of laminar imperfections (see ISO 10893-8) using the same ultrasonic transducers for both inspection requirements. Under these circumstances, the minimum lamination size under detection determines the percentage of the tube surface for scanning, according to ISO 10893-8. This part of ISO 10893 can also be applicable to the testing of circular hollow sections. This part of ISO 10893 is applicable to the thickness measurement of tubes with a specified outside diameter equal to or greater than 25,4 mm and a minimum wall thickness of 2,6 mm, unless otherwise agreed on.

To find similar documents by classification:

23.040.10 (Iron and steel pipes Steel pipes and tubes for specific use, see 77.140.75)

77.040.20 (Non-destructive testing of metals Non-destructive testing in general, see 19.100 Non-destructive testing of welded joints, see 25.160.40)

77.140.75 (Steel pipes and tubes for specific use Including hollow steel bars and sections for construction Steel pipes for conducting fluids, see 23.040.10)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.




Want this as a site license?

Designation Name

SS-EN ISO 10893-12:2011

Revision Level




Publication Date

April 20, 2011



Page Count


International Equivalent

EN ISO 10893-12:2011(IDT); ISO 10893-12:2011(IDT)