SS-EN-ISO-11114-2 › Historical Revision Information
Gas cylinders - Compatibility of cylinder and valve materials with gas contents - Part 2: Non-metallic materials
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 11114-2:2013 gives guidance in the selection and evaluation of compatibility between non-metallic materials for gas cylinders and valves and the gas contents. It also covers bundles, tubes and pressure drums. ISO 11114-2:2013 can be helpful for composite and laminated materials used for gas cylinders. It does not cover the subject completely and is intended to give guidance only in evaluating the compatibility of gas/material combinations. Only the influence of the gas in changing the material and mechanical properties is considered (for example chemical reaction or change in physical state). The basic properties of the materials, such as mechanical properties, required for design purposes are normally available from the materials' supplier and are not considered. The compatibility data given are related to single component gases but can be used to some extent for gas mixtures. Ceramics, glasses, and adhesives are not covered. Other aspects such as quality of delivered gas are not considered. ISO 11114-2:2013 is not intended to be used for cryogenic fluids (see ISO 21010).
To find similar documents by classification:
Directve 2008/68/EC of the European Parliament and of the council of 24 September 2008 on the inland transport of the dangerous goods
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN ISO 11114-2:2013
Revision Level
REPLACED BY SS-EN-ISO-19901-2
Status
Superseded
Publication Date
July 13, 2022
Language(s)
English
Page Count
28
International Equivalent
EN ISO 11114-2:2013(IDT); ISO 11114-2:2013(IDT)