SS-EN-ISO-20430 › Plastics and rubber machines - Injection moulding machines - Safety requirements (ISO 20430:2020)
SS-EN-ISO-20430
-
2020 EDITION
-
CURRENT
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This document specifies the essential safety requirements for the design and construction of injection moulding machines for the processing of plastics and/or rubber and provides information for their safe use. This document is applicable only to injection moulding machines with hydraulic and/or electrical drives for platen movement. This document deals with all significant hazards, hazardous situations and events relevant to injection moulding machines, when they are used as intended and under conditions of misuse which are reasonably foreseeable by the manufacturer (see Annex A) during the life cycle of the machinery (see ISO 12100:2010, 5.4). The following are not covered: machines on which the clamping unit can only be operated by the physical force of the operator; machines for which the hydraulic jack can only be manually operated; injection blow moulding machines; machines for reaction injection moulding; compression moulding machines and transfer moulding machines; direct-on sole moulding machines, unit sole and footwear component moulding machines, full shoe and boot moulding machines; design of an exhaust system; design and construction of the mould. NOTE Moulds and exhaust systems are not part of the machinery. This document is not applicable to injection moulding machines which are manufactured before the date of its publication.
To find similar documents by classification:
25.120.20 (Rolling, extruding and drawing equipment)
83.200 (Equipment for the rubber and plastics industries)
Revised Machinery Directive
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN ISO 20430:2020
Revision Level
2020 EDITION
Status
Current
Publication Date
July 9, 2020
Language(s)
English
Page Count
144
International Equivalent
EN ISO 20430:2020(IDT); ISO 20430:2020(IDT)