SS-EN-ISO-20763 › Petroleum and related products - Determination of anti-wear properties of hydraulic fluids - Vane pump method (ISO 20763:2004)
SS-EN-ISO-20763
-
2004 EDITION
-
CURRENT
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This International Standard specifies procedures for the determination of steel-on-steel anti-wear properties of hydraulic fluids by means of performance in a vane-type hydraulic pump. It covers a range of hydraulic fluids, both anhydrous and aqueous, intended for applications where high-speed sliding contacts, such as those found in a vane pump, are encountered. For mineral oils of categories HM and HV, and fire-resistant fluids of category HFD, the method is applicable to viscosity classes ISO VG 32, ISO VG 46 and ISO VG 68, as specified in ISO 3448. Under different specified conditions, the method is applicable to aqueous fire-resistant hydraulic fluids in categories HFA, HFB and HFC, as specified in ISO 12922, within the same viscosity classes. NOTE Viscosity classes below ISO VG 32 and above ISO VG 68 can be tested by this technique, but require different conditions of pump inlet viscosity, and have not been widely assessed. This International Standard is confined to the specified limiting values defined.
To find similar documents by classification:
75.120 (Hydraulic fluids Fluid power systems, see 23.100)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN ISO 20763:2004
Revision Level
2004 EDITION
Status
Current
Publication Date
Aug. 27, 2004
Language(s)
English
Page Count
21
International Equivalent
EN ISO 20763:2004(IDT); ISO 20763:2004(IDT)