SS-EN-ISO-6847 › Historical Revision Information
Welding consumables - Deposition of a weld metal pad for chemical analysis (ISO 6847:2013)
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This International Standard specifies the procedure to be used for deposition of a weld metal pad for chemical analysis. This International Standard applies to deposition of a weld metal pad by use of covered electrodes, wire electrodes for gas shielded metal arc welding, tubular cored electrodes for gas shielded metal arc welding and for non-gas shielded metal arc welding, tubular cored rods for gas tungsten arc welding, and wire-flux combinations for submerged arc welding. This International Standard is applicable to welding consumables for non-alloy and fine grain steels, high strength steels, creep-resisting steels, stainless and heat-resisting steels, nickel and nickel alloys, and copper and copper alloys.
To find similar documents by classification:
25.160.20 (Welding consumables Including electrodes, filler metals, gases, etc.)
Pressure equipment
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN ISO 6847:2013
Revision Level
2013 EDITION
Status
Superseded
Publication Date
June 23, 2013
Language(s)
English
Page Count
20
International Equivalent
EN ISO 6847:2013(IDT); ISO 6847:2013(IDT)