SS-ISO-16030 › Historical Revision Information
Pneumatic fluid power - Connections - Ports and stud ends
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This document specifies dimensions and performance requirements for ports and stud ends with parallel threads (G series thread) for pneumatic fluid power applications. It specifies reusable, positively retained seals for leak-free connections, for use at pressures from -0,09 MPa (-0,9 bar) up to 1,6 MPa (16 bar). This document is applicable for threaded ports and stud ends specified in new designs in pneumatic fluid power applications. WARNING Ports and stud ends conforming to this document are not intended to connect with ports and stud ends that conform to ISO 1179 (all parts) or threads that conform to ISO 7-1. As shown in Figure 1, significant differences in thread depth exists between ISO 16030 requirement and ISO 1179-1 (?1 and ?2) that makes ports and stud ends conforming to ISO 7-1 unsuitable.
To find similar documents by classification:
23.100.40 (Piping and couplings)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-ISO 16030:2023
Revision Level
2023 EDITION
Status
Current
Publication Date
Dec. 7, 2023
Language(s)
English
Page Count
24
International Equivalent
ISO 16030:2022