SS-ISO-1641-1 › Historical Revision Information
End mills and slot drills - Part 1: Milling cutters with cylindrical shanks (ISO 1641-1:2003, IDT)
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This part of ISO 1642 specifies the general dimensions of the following milling cutters with plain cylindrical, flatted cylindrical and threaded shanks: ? end mills, flat-ended or ball-nosed standard series and long series; ? slot drills short series and standard series. The dimensional characteristics of cylindrical shanks are in accordance with ISO 3338-1, ISO 3338-2 and ISO 3338-3. NOTE These same milling cutters with Morse taper shanks having a tapped hole are dealt with in ISO 1641-2, those with 7/24 taper shanks in ISO 1641-3. This part of ISO 1641 does not apply to solid hardmetal end mills and slot drills.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-ISO 1641-1:2015
Revision Level
2015 EDITION
Status
Superseded
Publication Date
Dec. 7, 2015
Language(s)
English
Page Count
16
International Equivalent
ISO 1641-1:2003(IDT)