SS-ISO-2780 › Historical Revision Information
Milling cutters with tenon drive - Interchangeability dimensions for cutter arbors - Metric series (ISO 2780:2006, IDT)
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This International Standard specifies the dimensions for interchangeability between milling cutters with tenondrive and the cutter seating of cutter arbors.It is applicable only to milling cutters of the metric series.It gives the interchangeability dimensions for:the milling cutters;the cutter seating on the arbor;the cutter retaining screw on the cutter arbor.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-ISO 2780:2015
Revision Level
2015 EDITION
Status
Superseded
Publication Date
Aug. 20, 2015
Language(s)
English
Page Count
20
International Equivalent
ISO 2780:2006(IDT)