SS-ISO-4586-1 High-pressure decorative laminates - Sheets made from thermosetting resins - Part 1: Classification and specifications (ISO 4586-1:2004, IDT)

SS-ISO-4586-1 - 2005 EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:


This part of ISO 4586 establishes a classification system for high-pressure decorative laminated sheets according to their performance and main recommended fields of application, including materials with special characteristics, for example postformability or defined reaction to fire. This part of ISO 4586 also specifies requirements on the properties of the various types of laminate covered by this classification. For several of the properties, more than one test method for checking the requirements is given. These methods have been included to cover cases where the results given by alternative methods are approximately equivalent, where expensive equipment of different types is already in satisfactory use, or where experience is limited to only one of the methods in certain countries. Requirements are specified for those types of material that are most generally used, but additional types may be added as required. The limit values specified apply to the most commonly used types of material, but within each classification it may be possible to obtain variants having much higher performance figures. These materials are characterized by their decorative surfaces, which are relatively hard and resistant to wear, scratching, impact, boiling water, domestic stains and moderate heat. They are intended for interior applications as follows: -- thin single-faced laminates usually less than thick, for bonding to a substrate; -- compact laminates, single- or double-faced, approximately to thick, which need to be rigidly supported without necessarily being bonded to a substrate; -- compact laminates, self-supporting, double-faced, usually thicker than , the thickness of which will be selected according to application and panel dimensions. The back surface of sheets having only one decorative face is made suitable for adhesive bonding to a substrate.

To find similar documents by classification:

83.140 (Rubber and plastics products Moulding or extrusion products should be classified according to specific products Transmission belts, see 21.220.10 Conveyor belts, see 53.040.20 Rubber and plastics coated fabrics, see 59.080.40 Footwear, see 61.060 Tyres, see 83.160)

83.140.20 (Laminated sheets)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

ORDER

Price:

$102.00        




Designation Name

SS-ISO 4586-1:2005

Revision Level

2005 EDITION

Status

Current

Publication Date

Feb. 11, 2005

Language(s)

English

Page Count

17

International Equivalent

ISO 4586-1:2004(IDT)