ASTM-A1053 › Historical Revision Information
Standard Specification for Welded Ferritic-Martensitic Stainless Steel Pipe
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers seam welded ferritic-martensitic stainless steel pipe intended for abrasive and general corrosion service. The pipes are classified according to sizes, from NPS 2 to NPS 36. The pipe shall be made using Electric Resistance Welding (ERW) or an automatic fusion welding process with no addition of filler metal during the welding process. All pipes shall be made from heat treated strip or plate, cold formed and welded. Tensile test, flattening test, hydrostatic test, and nondestructive electric test shall be made in accordance with the pipe specification to conform to the requirements specified.
Scope
1.1 This specification covers seam welded ferritic-martensitic (dual phase) stainless steel pipe intended for abrasive and general corrosion service. Nominal sizes are NPS 2 to NPS 36 inclusive, with nominal (average) wall thickness up to 0.75-in. (19 mm).
1.2 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents. Therefore each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. The inch-pound units shall apply unless the "M" designation is specified in the order.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
dual phase; ferritic-martensitic stainless steel; stainless steel pipe; steel pipe; welded steel pipe; ICS Number Code 23.040.10 (Iron and steel pipes)
To find similar documents by ASTM Volume:
01.01 (Steel--Piping, Tubing, Fittings)
To find similar documents by classification:
23.040.10 (Iron and steel pipes Steel pipes and tubes for specific use, see 77.140.75)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-A1053_A1053M-12R22
Revision Level
2012 R22 EDITION
Status
Current
Modification Type
New
Publication Date
March 30, 2022
Document Type
Specification
Page Count
4 pages
Committee Number
A01.10