ASTM-A269 › Historical Revision Information
Standard Specification for Seamless and Welded Austenitic Stainless Steel Tubing for General Service
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers grades of nominal-wall-thickness, stainless steel tubing for general corrosion-resisting and low- or high-temperature service, as designated in Table 1.
1.2 The tubing sizes and thicknesses usually furnished to this specification are 1/4 in. (6.4 mm) in inside diameter and larger and 0.020 in. (0.51 mm) in nominal wall-thickness and heavier.
1.3 Mechanical property requirements do not apply to tubing smaller than 1/8 in. (3.2 mm) in inside diameter or 0.015 in. (0.38 mm) in thickness.
Note 1—Additional testing requirements may apply for use in ASME B31.3 applications.
1.4 Optional supplementary requirements are provided and, when one or more of these are desired, each shall be so stated in the order.
1.5 The values stated in inch-pound units are to be regarded as the standard.
Keywords
austenitic stainless steel; seamless steel tube; stainless steel tube; steel tube; welded steel tube; ICS Number Code 23.040.10 (Iron and steel pipes)
To find similar documents by ASTM Volume:
01.01 (Steel--Piping, Tubing, Fittings)
To find similar documents by classification:
23.040.10 (Iron and steel pipes Steel pipes and tubes for specific use, see 77.140.75)
To find similar documents by Federal Supply Class Code:
FSC 4710 (Pipe, Tube and Rigid Tubing)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-A269-07
Revision Level
2007 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
March 1, 2007
Document Type
Specification
Page Count
6 pages
Committee Number
A01.10